Sony DHC-MD313 Primary Operating Instructions Manual page 23

2
Press EDIT and press +/–
repeatedly until "Name in ?"
appears.
CD
DISC
N a m
3
Press ENTER/YES.
The cursor flashes.
CD
DISC
Cursor
4
Press CHARACTER repeatedly
until the type of character you want
appears.
Each time you press the button, the
display changes as follows:
A (Upper case) n a (Lower case) n 0
(Numbers) n ! (Symbols)* n
n A...
* You can use the following symbols.
!"#$%&'() +,–./:;<=>?@_`
5
Press +/– repeatedly until the
desired character appears.
To enter a blank space, skip this step.
6
Press CURSOR /.
The character you selected in step 5 stops
flashing and the cursor shifts to the right.
CD
DISC
A
Cursor
LEVEL SYNC -
DBFB
e i n ?
LEVEL SYNC -
DBFB
(Space)
LEVEL SYNC -
DBFB
7
Repeat steps 4 through 6 to
complete the entire title.
If you enter an incorrect character,
pressCURSOR ? or / until the
character you want to change flashes,
then repeat steps 4 through 6.
To erase a character, press
CANCEL/NO while the character is
flashing. You cannot insert characters
between previously inserted characters.
8
Press ENTER/YES to complete the
labelling procedure.
Start over from step 1 and the titles
entered appear sequentially.
To cancel labelling
Press EDIT.
Note
Turn on the system POWER at least once a month,
otherwise the titles are erased from the memory.
To check the titles
Press DISPLAY while playback is stopped.
Each time you press the button, the display
changes as follows:
The disc title
The total number of tracks and the total
playing time
To erase a disc title
1 Press EDIT then press +/– repeatedly until
"Name Erase ?" appears.
2 Press ENTER/YES.
The disc title flashes.
"No Name" appears if there is no disc title
is stored.
3 Press +/– repeatedly until the disc title you
want to erase disappears.
4 Press ENTER/YES again.
"Complete" appears and the disc title is
erased.
To cancel erasing
Press CANCEL/NO.
23