Ford EXPLORER 2004 Technical Training Manual page 119

IC
The IC is connected to the CAN and UART-Based Protocol (UBP) networks.
•
On the CAN network, the IC communicates with the:
– PCM
– TPMS
– 4x4 Module (part of the PCM)
– ABS
•
On the UBP network, the IC communicates with:
– VSM
– RCM
The following chart shows the GEM functions that the IC has taken over:
GEM Delete Feature Comparison
FEATURE
Autolamps
Battery Saver
Beltminder Chime Control
Seat Belt Lamp Control
Airbag Lamp Redundant Chime
Delayed Accessory
Door Ajar Chime/Lamp
Head Lamps On Chime Control
Interior Lamps
Key On Ignition Chime Control
Puddle Lamp Control
Rear Defrost Timer
Wiper Controls (Front)
Wiper Controls (Rear)
ABS Lamp
Red Brake Lamp (Low Brake Fluid)
NOTE: When installing a new instrument cluster, the instrument cluster must be reconfigured. For additional
information, refer to Section 418-00 in the Workshop Manual.
2004 Explorer/Mountaineer New Model Technician Training
LESSON 4: ELECTRICAL
2002 2002.5/2003
GEM
GEM
GEM ARM/Cluster
GEM ARM/Cluster
GEM ARM/Cluster
GEM
GEM VSM/Cluster
GEM
GEM
GEM
GEM
GEM
GEM Wiper Motor
GEM Wiper Motor
Hardwire
Hardwire
12-AUG-03
2004
BSM BSM
Cluster Cluster
ARM/Cluster
ARM/Cluster
ARM/Cluster
Cluster Cluster
VSM/Cluster
Cluster Cluster
Cluster Cluster
Cluster Cluster
Cluster Cluster
Cluster Cluster
Wiper Motor
Wiper Motor
SCP CAN
SCP CAN
4-17