Messages - Sony CMT-GPX5 Operating Instructions Manual

Optional components
There is no sound.
• Refer to General item "There is no sound."
(page 23) and check the condition of the system.
• Connect the component properly (page 22) while
checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all the way.
• Turn on the connected component.
• Refer to the operating instructions supplied with
the connected component and start playing.
• Press FUNCTION repeatedly until "MD" or
"VIDEO" appears (page 22).
The sound is distorted.
• Set the volume of the connected component
lower.
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
Use buttons on the unit for the operation.
1
Disconnect the power cord.
2
Reconnect the power cord.
3
Press ?/1 to turn on the system.
4
Press x (CD stop), DSGX and ?/1 at the
same time.
The system is reset to the factory settings. You
should set the settings you made, such as the
preset stations, clock, and timer.

Messages

One of the following messages may appear or
flash in the display during operation.
CD/MP3
NO DISC
There is no disc in the player.
NO STEP
All of the programed tracks have been erased.
CD OVER
You have reached the end of the disc while pressing
and holding M during playback or pause.
STEP FULL
You tried to program 26 or more tracks (steps).
PUSH STOP
You pressed PLAY MODE during playback.
Tuner
COMPLETE
The preset operation ended normally.
Tape
NO TAB
You cannot record the tape because the tab has been
removed from the cassette.
NO TAPE
There is no tape in the tape deck.
Timer
SET TIMER
You cannot select the timer function when Play
Timer or Rec Timer are not set.
TIME NG
Play Timer or Rec Timer start and end times are set
to the same time.
PUSH SELECT
You tried to set the clock or timer during timer
operation.
SET CLOCK
You tried to select the timer with the clock not set.
continued
GB
25