ASSEMBLING AND PREPARING
Unpacking
Check your product box for the following items. If there are any missing accessories, contact the local
dealer where you purchased your product. The illustrations in this manual may differ from the actual product
and item.
Remote control and batteries(AAA)
1
Polishing cloth
(This item is not
included for all models.)
1
Gently wipe the spots on the cabinet with the polishing cloth.
2
Antenna Isolator Installation Guide
y Use this to install TV in a place where there is a voltage difference between GND of power and GND of antenna signal.
y
- If there is a voltage difference between GND of power and GND of antenna signal, the antenna contact might be
heated and excessive heat might cause an accident.
y You can improve the safety when watching TV by efficiently removing power voltage from TV antenna. Avoid
y
disconnecting the antenna Isolator after installation.
y Exterior of antenna isolator:
y
y Connection method :
y
- Connect Plug 1 with a signal cable.
- Connect Plug 2 with ANT input end on the back of TV.
"Equipment connected to the protective earthing of the building installation through the mains connection or through other
equipment with a connection to protective earthing - and to a cable distribution system using coaxial cable, may in some
circumstances create a fire hazard.
Connection to a cable distribution system has therefore to be provided through a device providing electrical isolation below a
certain frequency range (galvanic isolator, see EN 60728-11)"
When applying the RF Isolator, a slight loss of signal sensitivity can occur.
Owner's Manual
Ferrite core
(Depending on model)
Plug2
Plug1
Isolator
RF Coaxial Wire
RF Coaxial Wire
ASSEMBLING AND PREPARING
2
Isolator
This item is not
(
included for all models.)
This item is not
Power cord (
included for all models.)
Plug1
Plug2
ANTENNA
IN
Isolator
Isolator
STB
ANTENNA
IN
ANTENNA
IN
3
ANTENNA
IN
ANTENNA
IN