Onboard Headers And Connectors - ASROCK N68-GS4/USB3 FX Installation Manual

1.5 Onboard Headers and Connectors

1.5 Onboard Headers and Connectors 1.5 Onboard Headers and Connectors 1.5 Onboard Headers and Connectors 1.5 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
(see p.2 No. 17)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector
(39-pin IDE1, see p.2 No. 5)
connect the blue end
to the motherboard
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATA2 Connectors
(SATAII_1 (PORT 0.0):
see p.2, No. 6)
(SATAII_2 (PORT 0.1):
see p.2, No. 7)
(SATAII_3 (PORT 1.0):
see p.2, No. 8)
(SATAII_4 (PORT 1.1):
see p.2, No. 9)
USB 2.0 Headers
(9-pin USB3_4)
(see p.2 No. 12)
1 0 1 0
1 0 1 0 1 0
ASRock
FLOPPY1
Pin1
IDE1
PIN1
80-conductor ATA 66/100/133 cable
SATAII_1
(PORT 0.0)
SATAII_2
(PORT 0.1)
SATAII_3
(PORT 1.0)
SATAII_4
(PORT 1.1)
USB_PWR
P-
P+
GND
DUMMY
1
GND
P+
P-
USB_PWR
N68-GS4/USB3 FX Motherboard
the red-striped side to
Pin1
connect the black end
to the IDE devices
These four Serial ATA2 (SATA2)
connectors support SATA2
or SATA hard disk for internal
storage devices. The current
SATA2 interface allows up to
3.0 Gb/s data transfer rate.
Besides two default USB 2.0
ports on the I/O panel, there are
two USB 2.0 headers on this
motherboard. Each USB 2.0
header can support two USB
2.0 ports.