Speaker System Hookups - Sony TA-FE320R Operating Instructions Manual

Tape deck, DAT deck, or MD deck
Amplifier
TAPE1/DAT
RECOUT IN
Ç
L
R
ç
Use the configuration above to connect the OUTPUT and
INPUT jacks of:
—a tape deck or DAT deck to the TAPE1/DAT jacks.
—a tape deck or MD deck to the TAPE2/MD jacks.
Turntable
1 Remove the shorting plugs from the PHONO jacks before
connecting the cables (but not unless you connect a
turntable).
Do not attach the shorting plugs to any set of the RECOUT
jacks. Doing so may stop output from the amplifier or
cause the unit to malfunction.
2 Connect the audio connecting cords.
Amplifier
PHONO
IN
Ç
L
R
Note
To prevent hum, connect the earth lead to SIGNAL GND (y)
on the amplifier.
TV or video deck
Amplifier
AUX
IN
L Ç
R
EON CONTROL (TA-FE520R only)
Amplifier
EON CONTROL
IN
Ç
If your tuner is equipped with an EON CONTROL OUT
terminal, connect it to the EON CONTROL IN terminal on
the amplifier to allow use of the EON (Enhanced Other
Networks) function of the RDS (Radio Data System) (see
page 8).

Speaker System Hookups

Tape deck
OUTPUT INPUT
LINE LINE
Overview
L
Here you learn how to connect speakers to the
R
amplifier.
What cords will I need?
Speaker cord (not supplied) (1 for each speaker)
Turntable
Twist the stripped ends of the cord about 15mm. Be sure to
match the speaker cord to the appropriate terminal on the
components: + to + and – to –. If the cords are reversed, the
sound will be distorted and will lack bass.
Hookups
TV or video deck
OUTPUT
LINE
L
R
Tuner
EON CONTROL
OUT
Getting Started
SPEAKERS
SPEAKERS
IMPEDANCE USE 4 - 16
R L
+ +
PHONO TUNER CD AUX TAPE2/MD TAPE1/DAT
IN IN IN IN REC OUT IN RECOUT IN
L
EON CONTROL
– –
R
(+)
(–)
]
}
AC OUTLET
SWITCHED 100W MAX
IN
(+)
(–)
]
}
5 EN