Boutside Top Exhaust; Attach Mounting Plate To Wall - GE Profile PVM9005FMDS Installation Instructions Manual

B
OUTSIDE TOP EXHAUST
INSTALLATION OVERVIEW
B1. Attach Mounting Plate to Wall
B2. Prepare Top Cabinet
B3. Adjust Blower Motor
B4. Install Exhaust Adaptor
B5. Mount Microwave Oven
B6. Connect Ductwork
B1 ATTACH THE MOUNTING PLATE
TO THE WALL
A
C
Attach the plate to the wall using toggle bolts. At
least one wood screw must be used to attach the
plate to a wall stud. Recommended locations on the
mounting plate are indicated by A, B, C and D.
1 Remove the toggle wings from the bolts.
2
Insert the bolts into the mounting plate through the
holes designated to go into drywall and reattach
the toggle wings to
49-40755 Rev. 1
Installation Instructions
B
D
3 4
(Vertical Duct)
To use toggle bolts:
Spacing for Toggles More
Than Wall Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
Mounting Plate
Insert the toggle wings into the holes in the wall
3
and place the mounting plate against the wall.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed
flush against the wall and that the plate is properly
centered under the cabinet.
CAUTION
Be careful to avoid pinching
fingers between the back of the mounting plate
and the wall.
Tighten all bolts. Pull the plate away from the wall
4
to help tighten the bolts.
Bolt End
17