Listening To The Radio; Preset Tuning - Sony MHC-RV900D Operating Instructions Manual

Presetting radio stations (continued)
Other Operations
To
Tune in a station
with a weak
signal
Set another
station to an
existing preset
number
To change the AM tuning interval
(except for the European, Middle
Eastern and Philippine models)
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the system. While holding down
ENTER, turn the system back on. When you
change the interval, all the AM preset stations
are erased. To reset the interval, repeat the
same procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Tips
• The preset stations are retained for half a day even
if you disconnect the power cord or if a power
failure occurs.
• To improve broadcast reception, reorient or move
the supplied antenna near a window or outdoors.
GB
44
Do this
Follow the procedure described in
"Setting presets through manual
tuning".
Start over from step 1. After step
3, press . or > (or PRESET
– or + on the remote) repeatedly to
select the preset number you want
to store the other station.

Listening to the radio

You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station

— Preset Tuning

Preset radio stations in the tuner's memory first
(see "Presetting radio stations" on page 43).
1
Press TUNER/BAND repeatedly to
select "FM" or "AM".
2
Press . or > (or PRESET – or + on
the remote) repeatedly to select the
desired preset station.
Preset number Frequency