Troubleshooting - Black & Decker 641915-00 Instruction Manual

641915-00,FSCP200 Compressor
Performing repairs may expose voltage sources, moving parts or
compressed air sources, personal injury may occur. Maintenance
other than that recommended in the "Troubleshooting" section of this manual is
not recommended and should be performed by trained service personnel.
PROBLEM
Thermal
Low voltage.
overload
protector cuts
out repeatedly.
Improper ventilation/
temperature too high.
Defective check valve.
Defective valves.
Compressor does not turn
Excessive tank
off when compressor
pressure - safety
reaches "cut-out" pressure.
valve pops off.
Pressure switch "cut-out"
too high.
Air leaks at
Tube fittings are not tight
fittings.
enough.
Air leaks in air
Defective air tank.
tank or at air
tank welds.
3/14/06 7:31 AM Page 15

TROUBLESHOOTING

CAUSE
Extension cord is wrong
length or gauge. Check
extension cord.
Operate compressor in a
well ventilated area.
Contact a Trained Service
Technician.
Contact a Trained Service
Technician.
Set Auto/On/Off switch to
the "OFF" position, if the
unit does not shut off contact
a Trained Service Technician.
Contact a Trained Service
Technician.
Using a soapy water solution
check all exposed fittings for
leaks. If needed reseal
fittings with pipe sealant
tape and retighten securely.
Do Not Overtighten. If
leaks continue contact a
Trained Service Technician.
Air tank must be replaced.
Do not repair the leak.
Do not drill into, weld or
otherwise modify air tank
or it will weaken. The tank
can rupture or explode.
15
CORRECTION