Twistorr 74 Fs On Board Controller Installation - Agilent Technologies X3502-64170 User Manual

TwisTorr 74 FS On Board Controller Installation

The on board controller can be mounted in two position:


To install the controller proceed as described in the following
procedures.
Bottom Mounting
See the following figure.
1
2
3
4
5
6
7
TwisTorr 74 FS User Manual / 87-901-053-01
TwisTorr 74 FS On Board Controller Installation
bottom mounting (as per the complete system);
side mounting.
Turn the pump upside-down;
Screw the 4 fixing studs (provided with the accessories bag) into
the holes on the pum bottom;
Place the controller on the studs aligning the 4 rubber holes on
the top of the controller case;
Press the controller towards the pump;
Turn the pump up again;
Plug the line cord and connect the pump cable to the pump;
Connect the mating connector with the jumper on the interlock
signal to start the pump.
Technical Information
321/342
17