Bissell REWIND 18M9 User Manual page 12

M
aintenance and care
Replace headlight
1. Turn power OFF. Unplug vacuum from
electrical outlet.
2. Using a flat screwdriver or coin, insert into
the slot on the right of the lens and gently
push inner latch to the left to remove the lens.
3. Pull old bulb straight out of socket. Push new
bulb straight into socket until locked into
place.
4. Reposition lens by inserting the tab on
the left side and then pushing the right
side back into place.
turbobrush tool maintenance
select models include pet turboeraser
tool that follows same maintenance
instructions.
1. Turn power OFF. Unplug vacuum cord
from electrical outlet.
2. Turn tool so bottom side faces up and
remove the two screws.
3. Remove the faceplate and clear any
obstructions
4. Remove the brush from the drive belt to
clean debris.
5. Reposition the drive belt on the brush,
and place ends of brush in slots on the
side. Reposition faceplate and secure
with two screws.
12
w w w . b i s s e l l . c o m w w w . b i s s e l l . c o m
2.
2.
3.
4.
8 0 0 . 2 3 7 . 7 6 9 1 8 0 0 . 2 3 7 . 7 6 9 1