Pentair EVERPURE CONSERV LT-S Manual
  1. Manuals
  2. Brands
  3. Pentair Manuals
  4. Water System
  5. EVERPURE CONSERV LT-S
  6. Manual
Pentair EVERPURE CONSERV LT-S Manual

Pentair EVERPURE CONSERV LT-S Manual

High efficiency reverse osmosis (ro) processor
Hide thumbs
Table of Contents

Advertisement

Quick Links

EVERPURE
CONSERV
®
INTRODUCTION
The Everpure Conserv LT-S Processor is a pre-assembled solution designed to provide high purity water for steam
applications. It combines a number of water treatment technologies into one easy-to-install package. The Processor provides
reduction of sediment. It also limits corrosion* and scale* by reducing TDS, chlorine* and chloramines*.
INSPECTION
Before mounting the Conserv LT-S Processor, inspect the parts. Use the table and illustration provided to verify the
parts provided. If any parts are missing, contact Customer Service at 800.942.1153 (US only)/630.307.3000 or by email at
CSeverpure@pentair.com.
Parts
1. Wall Unit with GRO-75EN RO Membrane,
Cartridge in Place
2. 4CC Mineral Cartridge
3. 4FC5 Filter Cartridge
4. Storage Tank
5. Parts Bag Containing:
Bypass Plug
Red Tubing with Connecting Elbow
Power Cord
Blue Tubing
Angled Ball Valve
Ball Valve
TDS Meter
White Tubing
* Not performance tested or certified by NSF
FOODSERVICE
EVERPURE
LT-S HIGH EFFICIENCY REVERSE OSMOSIS (RO) PROCESSOR
®
1
®
CONSERV
LT-S HIGH EFFICIENCY RO SYSTEM INSTALLATION AND OPERATION GUIDE
®
®
Conserv LT-S
EV9975-20
2
3
5
4

Advertisement

Table of Contents
loading

Related Manuals for Pentair EVERPURE CONSERV LT-S

Summary of Contents for Pentair EVERPURE CONSERV LT-S

  • Page 1 Before mounting the Conserv LT-S Processor, inspect the parts. Use the table and illustration provided to verify the parts provided. If any parts are missing, contact Customer Service at 800.942.1153 (US only)/630.307.3000 or by email at CSeverpure@pentair.com. Parts 1. Wall Unit with GRO-75EN RO Membrane, Cartridge in Place 2.

  • Page 2: Safety Instructions

    Tools Required SAFETY INSTRUCTIONS NOTE: This appliance can be used by children aged from eight (8) years and above and persons • Hand or Electric Drill • Phillips Screwdriver with reduced physical, sensory or mental • Air Pressure Gauge • Towel capabilities or lack of experience and •...

  • Page 3: Operating Specifications

    WARNING: Before installing the Processor, make NOTE: Do not install where system will be exposed to certain your water supply complies with direct sunlight. the following operating specifications. NOTE: Make certain that installation complies with all Failure to do so may reduce the state and local laws and regulations.
  • Page 4 EVERPURE CONSERV LT-S PROCESSOR ® Secure Unit to Wall Remove RO Membrane Approximately 25 lbs (11.3 kgs) Operating Weight WATER YOU CAN TRUST ®...
  • Page 5 Connect Valve to Storage Tank Connect Tubing for Flushing 3/8" Tubing To Storage Tank 3/8" Tubing Supply CLOSE Water In Precharge Storage Tank 5-7 psi (0.34 bar, 0.034 MPa) OPEN 3/8" Tubing Product Water Prepare to Flush the Everpure 4FC5 Cartridge ®...
  • Page 6 Plug In Power Cord Unplug Power Cord Inlet Water Closed Valve OPEN As Shown Plugged Install Cartridge Flush to Drain Five (5) Minutes Prepare the Pentair GRO-75EN Cartridge for Use ® Replace Membrane Remove Cover WATER YOU CAN TRUST ®...
  • Page 7 Connect Tubing to Pentair GRO-75EN Cartridge ® Push White 3/8" Tubing into White Connector Remove Plug Storage Tank Not Shown Push Blue 3/8" Tubing into Blue Connector Push Red 3/8" Tubing into Red Connector Flush Pentair GRO-75EN Cartridge ® Plug In Power Cord...
  • Page 8 Set Blending Valve Plug In Power Cord OPEN One (1) Full CCW Turn of the Valve Unplug In Power Cord Closed Open Press 1/4 Turn or Less Solid Blue Blending Valve 2" Press 1/4 Turn or Less Solid Blue Blending Valve 2"...
  • Page 9 Install Everpure 4CC Cartridge ® Remove Port Plug Install 4CC Cartridge EVERPURE CONSERV LT-S HIGH EFFICIENCY RO SYSTEM INSTALLATION AND OPERATION GUIDE ® ®...
  • Page 10 Flush Storage Tank and 4CC Cartridge Plug In Power Cord OPEN CLOSE Repeat Steps 2 and 4 When Pump Turns Four (4) Times Off, OPEN valve WATER YOU CAN TRUST ®...

  • Page 11: Installation

    Your water supply is prefiltered to reduce dirt and chlorine that may foul the membrane. The RO membrane cartridge 1. Remove the Pentair GRO-75EN Membrane from the clip separates this prefiltered water into RO WATER and REJECT on the wall unit.
  • Page 12 1. Refer to Figure 3 for a general description of connection The Everpure 4FC5 Filter Cartridge is installed and flushed points. before the Pentair GRO-75EN RO and the Everpure 4CC Cartridges are installed. 2. Prepare the plumbing to accept the RO system.
  • Page 13 Connect Tubing to Pentair GRO-75EN: White Flush to Drain Figure 6 Install the Pentair GRO-75EN RO Membrane Blue Cartridge: The GRO-75EN RO Membrane Cartridge is installed in the vertical position. There are three (3) quick-connect ports that are labeled: •...
  • Page 14 NOTE: The blend adjustment valve will be opened one (1) port of the RO filter. full turn to take the initial reading. Flush the Pentair GRO-75EN RO Membrane 1. CLOSE the blend adjustment valve, then OPEN it one (1) ®...
  • Page 15 3. Adjust the mixing valve if needed and run blended water for two (2) minutes. Discard this water. 4. Repeat Steps 3, 4 and 5 until the light indicators change between solid blue and flashing blue. The blended water TDS should now be at 80 ppm. Install the Everpure 4CC Mineral Cartridge: ®...
  • Page 16 Replacement Cartridges: Everpure 4FC5 Filter Cartridge - EV9693-21 Everpure 4CC Mineral Cartridge - EV9627-45 Flow Controller Pentair GRO-75EN RO Membrane Cartridge - 4002575 ® The 4FC5 and 4CC Cartridges need to be changed when replacing the GRO-75EN RO Membrane Cartridge. All Red Tubing cartridges should be changed at the same time.
  • Page 17 7. The tubing for the removed GRO-75EN Cartridge must be connected together. Make a length of tubing with angle quick-connectors. Use the length of tubing with Sanitization Procedure with the Pentair Everpure 2JT two right-angled quick-connectors to connect the white Cartridge (EV9608-10) tubing at the top to the blue tubing at the bottom.

  • Page 18: Troubleshooting

    27. CLOSE the water supply valve and OPEN the application restrictor installed. The processor will not valve to remove pressure. operate correctly if the restrictor is removed. 28. Remove the tubing that connects the Pentair GRO-75EN ® 1. CLOSE tank valve, turn OFF cold water supply to the RO Membrane Cartridge white (top) and blue (bottom) processor, and OPEN the application valve.

  • Page 19: Replacement Parts

    Continue to slowly add air until water stops coming out REPLACEMENT PARTS of the valve. Contact your local Pentair Everpure Dealer for filter ® 4. Turn OFF the application equipment valve.

  • Page 20: Limited Warranty

    65.6768.5800 TEL • 65.6737.5149 FAX • CSEVERPURE@PENTAIR.COM EMAIL Pentair trademarks and logos are owned by Pentair plc or its affiliates. Third party registered and unregistered trademarks and logos are property of their respective owners. Because we are continuously improving our products and services, Pentair reserves the right to change specifications without prior notice.

Table of Contents