Direct Power On/Off Function; Effective Tools For Your Presentation - Sony VPL-CX86 Operating Instructions Manual

powered tilt adjuster extended may damage
the adjuster.
• Turn off the projector according to the
procedure explained in "Turning Off the
Power," then cool it down before storing the
projector in the carrying case.

Direct Power On/Off Function

If you will be using a circuit breaker to turn
the power for the entire system on and off,
set the direct power on function to "On."
When you turn off the power, you can also
just unplug the power cord without pressing
the ?/1 key. The internal circuitry will cause
the fan to automatically operate for a certain
time even after the power cord is removed.
Note
However, if the unit has been on for less than
15 minutes, the fan might not begin to turn as a
result of inadequate charging. In that case,
follow the procedure for turning off the power
as described in "Turning Off the Power" on
page 19.
Effective Tools for Your
Presentation
To enlarge the image (Digital Zoom
function)
You can select a section of the image to
enlarge. This function works when a signal
from a computer is input, or when a still
picture (except a movie picture) stored in a
"Memory Stick" is projected.
This function does not work when a video
signal is input.
1
Project a normal image, and press the
D ZOOM + key on the Remote
Commander.
The digital zoom icon appears in the
center of the image.
24
Other Functions
2
3
To return the image to its original size
Press the D ZOOM – key.
Just pressing the RESET key returns the
image back to its original size immediately.
To freeze the image projected
(Freeze function)
Press the FREEZE key. "Freeze" appears
when the key is pressed. This function works
when a signal from a computer is input or
when a still picture stored in a "Memory
Stick" is projected.
To restore the original screen, press the
FREEZE key again.
Digital zoom icon
Move the icon to the point on the
image you want to enlarge. Use the
arrow key (M/m/</,) to move the
icon.
Press the D ZOOM + key again.
The portion of the image where the icon
is located is enlarged. The enlargement
ratio is displayed on the screen for a few
seconds.
By pressing the + key repeatedly, the
image size (ratio of enlargement: max. 4
times) increases.
Use the arrow key (M/m/</,) to
scroll the enlarged image.