Mounting The Transmitter - Silvercrest SFS 52 B2 Operating Instructions Manual

If the synchronisation has been a success, the
receiver notifies you of the programmed call signal.
Should the receiver not react as described, repeat the
synchronisation.
NOTE
► To cancel synchronisation between the transmit-
ter and the receiver, you need to press and hold
the synchronisation button
seconds.
► Pull the receiver out of the mains socket and wait
about 10 seconds so that all connections bet-
ween the transmitter and receiver are terminated.

Mounting the transmitter

♦ Select a suitable positioning for the sender, close
to your outer door.
♦ Mark the positions for the required drill holes
with the help of the mounting plate
the holes for the supplied wall plugs
drill).
♦ Push the wall plugs into the drill holes and screw
the mounting plate
screws
♦ Push the transmitter onto the mounting plate
until it clicks audibly into place.
SFS 52 B2
.
GB │ IE │ NI │ CY
onto the wall using the
for about 5
and drill
(5 mm
│
15 ■