Table of Contents
Advertisement
2
Enter the password.
Enter the password that was set.
Note
If you call the customer service center because you have forgotten the password, you
will need to be able to verify the projector's serial number and your identity. (This
process may differ in other countries.) Once your identity has been confirmed, we will
provide you with the password.
To turn off the power
1
Press the I /
"POWER OFF? Please press
want to turn off the power.
Note
A message disappears if you press any key except the
press any key for five seconds.
2
Press the I /
The ON/STANDBY indicator flashes in green and the fan continues to run for
about 120 seconds to reduce the internal heat. Also, the ON/STANDBY
indicator flashes quickly for the first 40 seconds. During this time, you will not
be able to light up the ON/STANDBY indicator with the I / 1 key.
3
Unplug the AC power cord from the wall outlet after the fan stops running
and the ON/STANDBY indicator lights in red.
(Except when using the Direct Power On/ Off function.)
When you cannot confirm the on-screen message
When you cannot confirm the on-screen message in a certain condition, you can
turn off the power by holding the I / 1 key for about one second.
Direct Power On/Off function
If you will be using a circuit breaker to turn the power for the entire system on and off,
set the direct power on function to "On". You can turn the power on/off without pressing
the power key on the projector.
On air filter
To maintain optimal performance, clean the air filter whenever you replace
the lamp.
1
key.
I /
1 key again." appears to confirm that you
1
key again.
I /
1
key, or if you do not
Projecting
27
Advertisement
Table of Contents
