Sony GRAND WEGA KF 60DX100 Operating Instructions Manual page 78

Other Information
78
To program video equipment
1 1 1 1
Open the panel of the remote control.
2 2 2 2
Move the slide switch to the desired component type.
3 3 3 3
Press inside the panel.
CODE SET
You must perform step 4 within 10 seconds of step 3, or you must
start again from step 3.
4 4 4 4
Close the panel and enter the three-digit manufacturer's code number
using the 0-9 buttons.
5 5 5 5
Press .
ENTER
6 6 6 6
To check if the code number works, aim the LCD projection TV's
remote control at the component, open the panel, and press the green
POWER button. If it responds, the programming is completed. If not, try
using the other codes listed for that manufacturer.
Tips
If more than one code number is listed, try entering them one by one
until you come to the correct code for your component.
If you enter a new code number, the code number you previously
entered at that setting is erased.
In some rare cases, you may not be able to operate your component with
the Sony remote control. In this case, use the component's own remote
control unit.