Polaris TRAIL BOSS 325 2001 Manual page 24

MAINTENANCE
LUBRICATION
9. Steering Post
7. Front A-Arm
Pivot Shaft
Ill. Item
#
5 Front Wheel Bear-
ings
6 Ball Joint
7 Front A-Arm Pivot
Shaft
8 Tie Rod Ends
9 Steering Post Bush-
ings
10 Rear Axle Bearings
11 Swing Arm Bush-
ings
* More often under severe use, such as operated in water or under severe loads.
¡
Semi-annually or 50 hours of operation (refer to Maintenance Schedule for additional information)
©
Annually or 100 hours of operation (refer to Maintenance Schedule for additional information)
¢
Grease conforming to NLGI No. 2, such as Polaris Premium All Season Grease, Conoco Superlube M or
Mobilegrease Special
2.6
8. Tie Rod End
D
6. Ball Joint
Lube Rec.
Sealed; Replace Inspect and replace bearings if necessary
Polaris All Season Locate grease fitting on back side of struts and
Grease¢ grease with grease gun.
Polaris All Season Locate grease fitting on pivot shaft and grease with
Grease¢ grease gun.
Polaris All Season Lift boot. Clean away dirt and grease. Apply fresh
Grease¢ grease by hand and reassemble.
All Season Locate fittings on upper and lower steering post and
Grease¢ grease with grease gun.
Polaris All Season Locate grease fitting on eccentric and grease with
Grease¢ grease gun.
Polaris All Season Locate grease fitting on swing arm and grease with
Grease¢ grease gun.
10. Rear Axle Bearings
5. Front
Wheel
Bearings
Method
11. Swing Arm
Bushings
Frequency*
Annually ©
Semi-annually
¡
Semi-annually
¡
Semi-annually
¡
Semi-annually
¡
Semi-annually
¡
Semi-annually
¡