Figure 3. Plugging the power cords into the power supplies
9. Attach all cables to the rear of the server.
Figure 4. Rear ports
Table 1. Input and output ports
Identifier
1
2
3
4
10. Plug the system power cords and the power cords for any other attached devices into the alternating
current (AC) power source.
11. Continue with "Completing server setup" on page 8.
Description
USB 2.0 used for keyboard and mouse.
Certain USB drives might be too wide to fit properly into
the USB ports on the rear of the system. Test the fit your
USB drive before proceeding.
Ethernet Intelligent Platform Management Interface
(IPMI)
Serial IPMI
Video Graphics Array (VGA) used for monitor. Only the
1024 x 768 at 60 Hz VGA setting is supported. Only up
to a 3-meter cable is supported. Text based capability is
only supported at this time.
Installing and configuring the system
7