Sony MZ-DN430 Operating Instructions Manual page 27

On cleaning
• After wiping the player casing with a soft
cloth slightly moistened with water, wipe it
again with a dry cloth. Do not use any type of
abrasive pad, scouring powder or solvent such
as alcohol or benzene as this may mar the
finish on the casing.
• Wipe the disc cartridge with a dry cloth to
remove dirt.
• Dust on the lens may prevent the unit from
operating properly. Be sure to close the disc
compartment lid after inserting or ejecting an
MD.
• To maintain good sound quality, use a soft
cloth to clean the plugs of the headphones/
earphones. A dirty plug may cause noise or
intermittent breaks in the sound during
playback.
• Clean the terminals periodically with a cotton
swab or a soft cloth as illustrated.
Dry battery compartment
When recording with the
supplied application software
Before you remove the MD after the
transfer of audio data from your
computer has completed
Make sure that "TOC Edit" has disappeared in
the display, and then press the x (stop) button.
If the power source (battery)
accidentally becomes disconnected
during recording
The lid may refuse to open. If this happens, do
not open the lid by force. Do the steps below
instead.
1 Connect the power source (battery) firmly to
the player.
2 Press the OPEN button to open the lid.
Terminals
To protect a recorded MD
To record-protect an MD, slide open the tab at
the side of the MD. In this position, the MD
cannot be recorded. To record again, slide the
tab back so the tab is visible.
Back of the MD
If you have any questions or problems
concerning your player, please consult your
nearest Sony dealer. (If a trouble occurred when
the disc was in the player, we recommend that
the disc be left in the player when you consult
your Sony dealer so that the cause of trouble
may be better understood.)
When consulting your Sony dealer, be sure to
bring the player and the headphones/earphones.
Tab
Recorded material is
protected.
Recorded material is
not protected.
27