Connecting To A Power Source; Using The Dry Batteries - Sony D-CJ506CK Marketing Operating Instructions Manual

B Connecting to a power source
You can use the following power sources:
• LR6 (size AA) alkaline batteries
• AC power adaptor
For the battery life, see "Specifications."

Using the dry batteries

Note
Be sure to remove the AC power adaptor when
using the dry batteries.
1
Open the battery compartment lid.
2
Insert two LR6 (size AA) batteries
by matching the 3 to the diagram
in the battery compartment.
Insert the # end first
(for both batteries).
To remove the dry batteries
Remove the batteries as illustrated below.
When to replace the batteries
You can check the remaining power of the
batteries in the display.
r
r
r
(rear)
r
r
Lo batt*
* Beep sounds.
When the batteries are depleted, replace both
batteries with new ones.
Notes
• The indicator sections of
the remaining battery power. One section does
not always indicate one-fourth of the battery
power.
• Depending on operating conditions, the indicator
sections of
Battery power is full.
Battery power is getting low.
Battery power is low.
Batteries are depleted.
roughly shows
may increase or decrease.
(Continued)
23