Preparing The Remote Commander - Sony DPP-FP50 Fall 2005 Operating Instructions Manual

5 Preparing the
remote commander
1
Remove the insulation sheet from
the remote commander.
With the insulation sheet removed
from the lithium battery, the remote
commander is ready for use.
2
Point the remote commander to
the remote sensor on the printer
and then press a button to
operate the printer.
You can use the buttons on the remote
commander in the same way as those
identical buttons on the printer.
Remote sensor
Note
Pressing CANCEL button on a remote
commander for more than one second does not
function.
GB
16
Friction seal
Replacing batteries
When the printer does not respond to the
remote commander, the battery may run
out.
1
Push in the tab (1) and then slide
out the battery compartment lid
(2).
2
Remove the used battery and
then insert a new lithium battery
(CR2025) into the compartment
with the + and – properly aligned.
3
Slide the battery compartment lid
back into the commander until it
clicks into place.
WARNING:
Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.
Notes
• The button-type battery CR2025 is used in the
remote commander. Do not use a battery
other than the CR2025.
• Point the remote sensor away from strong
light sources such as direct sunlight or
overhead lighting. Otherwise, the remote
commander may not function properly.
Lithium battery