Table of Contents
Advertisement
Connecting with a digital camera or other external device
Symptom
Check
The PictBridge
• Is the digital camera
mark does not
appear on the LCD
• Is the 1 (on/standby) button
screen of the
digital camera.
• Does your digital camera
• Is the USB setting of your
You connect and
disconnect the
USB cable, but
nothing happens.
You cannot stop
printing even if
you pressed
CANCEL.
You cannot make
Index prints
connected correctly?
turned on?
support PictBridge?
—
camera in PictBridge mode?
—
—
—
Cause/Solutions
c Connect the cable correctly.
c Turn on the 1 (on/standby) button.
c See the manual supplied with your
camera, or consult with the manufacturer.
c Is a memory card inserted in a slot of the
printer? If there is a memory card inserted,
remove it.
c Set the USB setting of your camera to the
PictBridge mode.
c The printer has developed an over-current
error. Unplug the AC power cord of the
printer, plug it in again, and then press the
1 (on/standby) button to recover from the
error.
c The next print from the one currently
printed will be canceled.
c Depending on the digital camera you are
using, you cannot cancel printing from the
printer. Operate the digital camera to stop
printing. Refer to the operating
instructions of the digital camera.
c The printer cannot print Index prints
during DPOF printing. To make Index
prints, insert the memory card directly
(.page 25).
Continued
GB
55
Hide quick links:
Advertisement
Table of Contents
