Handle Positions - Bissell 3750 SERIES User Manual

O
peration
Power switch/brush switch continued
the brush switch is located just below the handle
on the front of the detachable cylinder next to the
power switch. this switch turns the rotating brush
on and off. the brush switch should be in the
"on" (I) position for normal carpet cleaning. you
may want to turn the brush switch "off" (o) for
bare floor cleaning or other delicate surfaces.
notE: your bISSEll lift off vacuum is
equipped with a special internal switch that
turns the rotating brush off whenever the
unit is in the upright position.

Handle positions

1. Upright – For storage and above floor
cleaning with tools.
2. Normal cleaning – Press the handle release
pedal with your foot to recline.
Power height adjustment
the powerfoot on your bISSEll lift-off can be
adjusted to clean several floor surfaces.
notE: for optimal cleaning performance,
adjust to the lowest practical setting. If
your cleaner is difficult to push, adjust to
the next higher setting.
1. Place handle in upright position.
2. Turn height adjustment knob to desired setting.
lowest Setting
Medium Settings
highest Setting
notE: you may also adjust the setting while
in the normal cleaning position.
attEntIon bERbER
caRpEt oWnER:
Some bERbER carpets have a tendency
to fuzz with wear. Repeated passes with
your vacuum over the same area may
aggravate this condition. consider using
the highest height setting or turning off
the rotating brush for this type of carpet.
w w w . b i s s e l l . c o m
Tip:
Your vacuum feature a Quick Release
Cord Wrap. To remove the power cord
quickly and easily, rotate the upper
cord wrap towards floor, and slip power
cord from upper and lower cord wraps.
Tip:
– For bare floors.
– For short and
medium pile
carpets.
– For plush pile
carpet.
Power
Before cleaning under low furniture,
check area first for objects that
might harm the unit or block the
vacuum hose.
Brush
7