Adjusting The Screen Angle - NEC NP-02HD Installation Manual

Projector Adjustment and Connecting

3-6-2. Adjusting the Screen Angle

Preparation:
Display the zoom/focus adjustment screen by using the following procedure.
[1] Press the MENU button on the projector's control panel.
"Title Select" appears on the projector's LC display.
[2] Select "Configuration" menu using the LEFT/RIGHT buttons.
[3] Press the DOWN button.
[4] Select "Lens Control" using the LEFT/RIGHT buttons.
[5] Press the DOWN button.
[6] Press the ENTER button.
"Focus Zoom" is displayed and you can adjust the focus/zoom.
1
Press the LEFT/RIGHT buttons to roughly
adjust the screen size so that the screen
height and the image height are the same.
2 Press the UP/DOWN buttons to roughly
adjust the focus.
3 Adjust the surface on which the projector is
set up and the level adjuster of the projec-
tor to adjust the setup position, height, and
tile (front-back and left right) of the projec-
tor so that the projected image is level at
the screen center.
4
Use the LEFT/RIGHT buttons again to
adjust the screen size so that the projected
image is kept 0.5 to 1 crosshatch cell por-
tions higher than the top edge of the screen.
5
Finally adjust the focus using the UP/
DOWN buttons.
6
Press the EXIT button several times.
The projector exits the menu and goes back to the regular
screen.
110