Parts Replacement And Adjustment Procedures - Sullair ES-6 Series User Manual

SECTION 6
6.6 PARTS REPLACEMENT AND
ADJUSTMENT
PROCEDURES
WARNING
Before doing compressor maintenance,
disconnect compressor from power source
and lock out power source. Isolate
compressor from line pressure by closing
recommended discharge shut-off valve and
releasing all internal pressure
from compressor.
Figure 6-1: Fluid Filter (P/N 250026-982)
1. Pressure Gauge
3. Fluid Fill Plug
5. Sight Glass
(I) Replacement Element Kit P/N 250028-032
F F R
LUID ILTER EPLACEMENT
Refer to Figure 6-1. For maintenance schedule,
consult Table 3-7: Lubrication Guide.
1. To prevent spillage and loss of reusable fluid,
place a contaminate-free fluid receptacle
beneath fluid drain valve and fluid filter.
2. Temperature Gauge
4. Fluid Filter Element (I)
6. Fluid Ball Valve
2. Drain fluid by removing fluid drain valve cap
at tee located beneath compressor (for com-
plete fluid change, drain fluid from cooler).
3. Using a strap wrench, remove the old ele-
ment and gasket.
4. Clean gasket seating surface.
5. Apply a light film of fluid to the new gasket.
6. Hand tighten new element until gasket is
seated.
7. Continue tightening element an additional 1/
2 to 3/4 turn.
8. Replace fluid. DO NOT OVERFILL.
9. Restart compressor and check for leaks.
Figure 6-2: Air Filter (P/N 02250111-680)
1. Cover
3. Air Filter Element (I)
(I) Replacement Element Kit P/N 02250111-804
A F M
IR ILTER AINTENANCE
Refer to Figure 6-2. Air filter (P/N 02250111-680)
maintenance should be performed every six months
or more frequent if conditions so require.
ES-6 USER MANUAL
2. Pre-Filter
4. Base
69