Table of Contents
Advertisement
HANDLING THE UNEXPECTED
2. Remove the holding clips (A) and (B) by inserting a flat tip screwdriver
and lifting the center pins up.
Make sure to reinstall the clips after inspecting the fuses.
3. Pull the inner fender back.
4. Pull the lock tab to the direction shown in the image and pull out the
fuse box. Push the tabs to remove the cover.
n
Interior Fuse Box
Driver's Side Interior Fuse Box
Located under the dashboard (behind
the instrument panel). Fuse locations
are shown on the label on the side
panel (under the steering column).
Locate the fuse in question by the fuse
number and label number.
98 |
Passenger's Side Interior Fuse Box
Located on the lower side panel. Take
off the cover to open.
Inspecting and Changing Fuses
n
1. Turn off the vehicle, including all lights and accessories.
2. Remove the fuse box cover.
3. Check the large fuse in the engine compartment.
If the fuse is blown, use a Phillips-head screwdriver to remove the
screws and replace the fuse with a new one. Reinstall the screws.
4. Inspect the small fuses in the engine compartment and the vehicle
interior.
If there is a burned out fuse, remove it with the fuse puller and replace
it with a new one.
Replacing a fuse with one that has a higher rating greatly increases the
chances of damaging the electrical system.
HANDLING THE UNEXPECTED
| 99
Advertisement
Table of Contents
