Drive-Cliq Interfaces - Siemens SIMOTION D4x5 Series Manual

Interfaces

4.2 DRIVE-CLiQ interfaces

Non-usable interfaces
Table 4-2
Interface name
RS232 interface
3. Ethernet interface (if fitted)
Interface for BOP
4.2 DRIVE-CLiQ interfaces
DRIVE-CLiQ interfaces
All SINAMICS S120 drive system components, including the motors and encoders, are
interconnected by a shared serial interface called DRIVE‑CLiQ. The standardized cables and
connectors reduce the variety of different parts and cut storage costs.
DRIVE‑CLiQ has the following properties:
● Automatic detection of components by the Control Unit
● Standardized interfaces to all components
● Uniform diagnostics down to the components
● Complete service down to the components
● 24 V / 450 mA per DRIVE‑CLiQ interface are provided for the connection of encoders and
Position of connectors
Figure 4-1
50
Overview of interfaces that cannot be used for SIMOTION D
measuring systems.
Note:
The DRIVE‑CLiQ cables with 24 V supply should be used only for components that require
this (e.g. motors with a DRIVE‑CLiQ interface).
B
8
1
A
Position of the DRIVE‑CLiQ interfaces on the D4x5
Interface
X140
X127
-
Connector type
9-pin SUB-D connector
RJ45 socket connector
8-pin terminal strip
SIMOTION D4x5
Manual, 04/2014