Selecting The Type Of Windows Security; Enabling The Automatic Start-Up - Siemens MK8000 Quick Reference Manual

Installation
3.2.2

Selecting the type of Windows security

3.2.3

Enabling the automatic start-up

20
Building Technologies
Fire Safety & Security Products
The MK8000 installation procedure needs to define a new 'internal' Windows user
('DMS8000_PROC', default password = 'Dixie#65A39!PWD') and assign it to the
administration user group. This is required for handling the internal inter-process
communication.
Note that the 'DMS8000_PROC' user must be defined (and maintained) on all the
PCs involved in the OPC communication, both server and client(s).
Note: Do not remove this user.
During the installation, the MK8000 user can be defined in two different ways:
–
Standard security: the internal user is automatically created with the name
'DMS8000_PROC'.
–
Restricted security: the internal username and password can be specified as
desired. You can specify a new user account or an existing one.
During the installation procedure of MK8000 software, you are asked to specify
whether the user security is handled in standard or restricted mode.
In both cases, the internal user information can be changed later using the 'Spe-
cial_UT' utility application (see page 29).
During setup, you will be also prompted to choose whether to enable the automatic
start of the MK8000 server at start-up. Unless you need to perform testing or trou-
bleshooting, it is usually best to enable auto-start. If you need to change this set-
ting for any reason, please refer to Appendix B, "Enabling & disabling MK8000
auto-start", p.78.
048_DMS_MK8000_ICC_MP4.10_A6V10062407_a_en.doc
06.2007