Bissell PROheat 25A3 Series User Manual page 11

Carpetcleaning
1. Plug the deepcleanerinto a proper outlet.
Set ReadyTools dial to the FloorCleaning
setting.Turnthe power on by pressingthe
red power switch on the back of the unit
with yourfoot. Turnheaterswitch (located
on side of unit) to the on position.Allow one
minute for the built-in heaterto warm up
beforecleaning.
NOTE: T hePreHeatwill befullywarmed
andwill provideoptimal p erformance after
a minuteof continuous heatedcleaning.
2. With yourfoot, pressthe gray handlerelease
leverlocatedon the back of unit below
water tank to detenthandle.
3,
While pressingthe spray trigger,make one
slow forward wet pass and anotherback.
Let the built-in heater,BISSELL advanced
deep cleaningformula, and DirtLifter
PowerBrushdo the work for you.
Caution:Do notoverwet.
Releasethe spraytrigger and make one
slow forward and backwardpass over the
same area to removeany residualdirty
water andaid in drying.
Repeatcleaningpassesuntil solution
beingsuctionedup appears clean.Continue
passeswithout pressingthe trigger until
you can't see any more water being
suctionedup.
HandbRebs
' Power Switch
Switch
WARNING:
To reducethe risk of fire
and electricshock due to
internalcomponent
damage,useonlyBISSELL
cleaningfluids intendedfor
usewith the deep cleaner.
Non-BISSELL cleaning
solutionsmay harm the
machineand void
the warranty.
www.bissell,com 800.237.7691
/11
ug120-4078 25A3 908.indd 11 10/14/08 1:21:05 PM