Cossiga Linear Series User Manual

SERVICING
key to maintaining your cabinets
Accessing fans and coil (RF)
1.
2. 3.
Unscrew base plates Remove trays Lift+ remove grills
Deck height adjustment (RF)
Use brackets provided to
CERAMIC CLEANING
To thoroughly clean your glass ceramic cooktop, Once the glass ceramic cooktop has cooled,
first remove dirt and food with suitable metal put a few drops of suitable cleaner on it and
scraper or special sponge for glass ceramic rub it on with a paper towel, a clean cloth or an
cooktops. approved cleaning sponge.
CONTROLLER INSTRUCTIONS
DIXELL CONTROLLER ONLY
DEFROST
COMPRESSOR ON
( RF OR RA UNITS)
(RF OR RA UNITS)
UNIT DEFROST WHEN FLASHING
HEATING ELEMENTS ON
(HT & BM UNITS)
COMPRESSON IS OFF
LED LIGHT
SWITCH
DEFROST
PRESS FOR MORE THAN
3 SECONDS TO TURN ON
EXTRA DEFROST
1
PRESS AND HOLD
FOR 3 SECONDS
4.
Lift panel to expose fans and coil
adjust deck
height
AVOID using ammonia based glass cleaners
DO NOT use abrasive sponges or scouring pads
DO NOT use oven cleaner
DO NOT use earthware or cast iron plates
DO NOT use bathroom or household sponges
Then wipe the glass ceramic cooktop with a
damp cloth and dry it with a clean cloth or an
approved cleaning sponge.
AIRFLOW FAN ON
ON/OFF
SET/CONFIRM
TO ADJUST TEMPERATURE
2 3 4
SET POINT WILL PUSH ARROWS TO PRESS SET TO
FLASH ADJUST SET POINT CONFIRM
LET'S
GET
STARTED
Your cabinet has been delivered fully assembled.Please check nothing has moved during transit
.
1
Check bench cutout is as per table
on website
All controllers are preset
for certified food safety
- avoid unnecessary
adjustments
CM & BM
The control
panel is on the
right hand side
when looking
from the rear of
the unit
CM & BM
USER GUIDE FOR LINEAR SERIES
Thank you for purchasing a Cossiga food display cabinet
This is a guide only. If you are unsure of any aspects of the installation or operation, please contact
us or visit our website
SAFETY
Always disconnect this appliance before cleaning and servicing
Servicing should only be carried out by an approved service agent,
registered electrician or refrigeration engineer
Do not use a multi-box or overload your power supply
INSTALLATION
AVOID
• Drafts from doorways
• Airflow from air-conditioning ducts
• Hot air from motors i.e. refrigerators
• Direct sunlight
2.
Lift unit into place use lifting brackets
Bolts retained
for fixing gantry
post
Lifting brackets are
fitted to assist
removing the unit from
the packaging and
placing in cabinetry.
Use a bar that can
fit through the 35 x
35mm square hole (not
Lifting
Brackets supplied)
Supplied
GANTRY ASSEMBLY
1
.
RF
Bain Marie (BM) & Ceramic Top(CM)
Remove side post cover lift up and
out from the base
Position gantry assembly onto base
screw up fixing bolts with washers
from underneath on both sides.
Lamp power cable - feed through
large hole in deck
RF
2
.
Plug into socket and screw up.
www.cossiga.com
Also applies
to heat
disruption on Bain
Marie and Ceramic
Top units
Use four people lifting
each corner.
After the unit has been
placed in the required
position remove lifting
brackets.Retain bolts
and screws for fixing
the gantry post.
Refrigerated(RF) gantry screw
down from above.
Screw gantry assembly down on
to base.
3
.
Install Cover
On each side post slide up
the post cover panel.
position into clips and pull
down to fit.