Configuration Scenarios - Cisco 800 Design Manual

Configuration Scenarios

Configuration Scenarios
Cisco 800 Fast Step Setup provides a limited number of configuration scenarios that can be built using
the Setup wizard or a CFG file and performs comprehensive testing for each scenario, as opposed to a
Cisco 800 Fast Step IOS template (TPL), which can configure any scenario because Setup does not test
TPL configurations. A summary of Setup's capabilities is shown in Table 1-1.
Table 1-1
Section
WAN Support
Connection Support
Firewall Support
1. Point-to-Point Protocol (PPP)
2. Basic Rate Interface (BRI)
3. basic telephone service (POTS)
4. Routing Information Protocol (RIP)
5. Port Address Translation (PAT)
6. Network Address Translation (NAT)
7. File Transfer Protocol (FTP)
Cisco 800 Fast Step Software Design Guide
1-4
Cisco 800 Fast Step 2.3 Support
Support
T1/E1 leased line.
Frame Relay PPP
2
ISDN BRI (supports PPP).
Serial connections on Cisco 805 series router. Supports PPP, Frame Relay, and
HDLC.
3
POTS on Cisco 802 and Cisco 804 series routers.
Two connections maximum.
IP and IPX only.
Dual connection to a corporate network (requires that RIP
site).
Always uses PAT
Allows publication of Web, mail, or FTP
servers are on a single LAN.
1
.
5 6
and NAT for connection to the Internet.
7
servers on the Internet when the
Chapter 1 Introduction to Design
4
is on at the central
OL-10373-02