Table of Contents
Advertisement
Symptom
After a WPS registration
attempt the WLAN LED
keeps flashing and the
desired client was not
registered.
You cannot open a connec-
tion from a wireless device
to the Gigaset SE366 WLAN.
Possible cause and remedial actions
More than one client has tried to register.
ì
Check if maybe an external device has registered
with your network.
If yes:
ì
Change the WPA PSK key manually as soon as
possible (see page 69) and perform the WPS
registration via PIN (see page 68).
If no:
ì
Try to register again after a short time period.
Either encryption is enabled on the Gigaset SE366
WLAN but not on the wireless network adapter, or it is
not using the correct key or is using another type of
encryption.
ì
Activate the same encryption on the network
adapter with the correct key or use the WPS
function.
If you do not know the key, you will have to reset
the Gigaset SE366 WLAN (see page 20).
Warning: Please bear in mind that this will return
all the configuration settings to the factory
settings.
The Wireless Network function is deactivated.
ì
Check whether the Wireless Network function is
deactivated and, if so, activate it (see page 65).
The PC does not have a wireless connection.
ì
Use the Windows device manager (My Computer –
Properties) to check whether the network connec-
tion is functioning. If you see a red cross or a ques-
tion mark, then the driver may not have been
installed or there is a resource conflict. Follow the
Windows instructions to remedy the problem.
Appendix
97
Advertisement
Table of Contents
