General Notices On Use In Hazardous Areas According To Ul Hazloc / Fm - Siemens SIMATIC CC712 Operating Instructions Manual

LAN connection (Local Area Network)
A LAN or LAN segment with all the interconnected devices should be contained completely
in a single low voltage power distribution system in a building. The LAN is designed either
for "Environment A" according to IEEE802.3 or "Environment 0" according to IEC TR
62102.
Do not connect any electrical connectors directly to the telephone network (Telephone
Network Voltage) or a WAN (Wide Area Network).
EXPLOSION HAZARD
Do not press the SET button if there is a potentially explosive atmosphere.
3.1.3

General notices on use in hazardous areas according to UL HazLoc / FM

This equipment is suitable for use in Class I, Division 2, Groups A, B, C and D or non-
hazardous locations only.
This equipment is suitable for use in Class I, Zone 2, Group IIC or non-hazardous locations
only.
EXPLOSION HAZARD
You may only connect or disconnect cables carrying electricity when the power supply is
switched off or when the device is in an area without inflammable gas concentrations.
Do not remove or replace while circuit is live when a flammable or combustible atmosphere
is present.
Explosion hazard
Do not disconnect equipment when a flammable or combustible atmosphere is present.
SIMATIC CC712
Operating Instructions, 05/2019, C79000-G8976-C503-01
WARNING
WARNING
WARNING
WARNING
WARNING
Installation, wiring, commissioning
3.1 Important notes on using the device
27