While Editing - Sony WALKMAN MZ-NH1 Operating Instructions Manual

Symptom
There is no R-channel
sound output when
playing a track recorded
from a cassette deck or
through an amplifier, or
when listening to sound
from a cassette deck or
amplifier.

While editing

Symptom
The lid does not open.
Editing cannot be done. • The power source has been disconnected or a power outage has
Non-audio data cannot
be erased
Tracks cannot be
combined.
The disc cannot edit on
other component.
84
Cause/Remedy
• There is no R-channel output if the cassette deck or an amplifier is
connected with a monaural cord.
, Make sure to use a stereo connecting cord. If, however, the
connected equipment is monaural, there will be no R-channel
sound output even with a stereo connecting cord.
Cause/Remedy
• The power sources have been disconnected during recording or
editing, or the battery have been exhausted.
, Set the power sources again, or replace the exhausted battery
with new ones.
occurred during editing.
, The editing done to that point is not saved to the disc. Do the
editing operation again.
• Non-audio data cannot be erased with the Erase function.
, Confirm the contents by connecting the recorder to your
computer. If it is okay to delete the contents, then perform the
Format function (page 64).
• This is due to the MiniDisc system limitations. When the tracks are
scattered and the length of each track is short*, you may not be
able to combine the tracks.
* Combining tracks of the following lengths may not be possible.
Hi-MD mode
Linear PCM stereo: 9 seconds or less
Hi-SP stereo: 8 seconds or less
Hi-LP stereo: 32 seconds or less
MD mode
SP stereo: 12 seconds or less
LP2 stereo/Monaural: 24 seconds or less
LP4 stereo: 48 seconds or less
• You cannot combine tracks recorded in different recording modes,
e.g., a track recorded in stereo and a track recorded in monaural;
nor can you combine a track recorded with digital connection and a
track recorded with analog connection.
• The component does not support MDLP or Hi-MD.
, Edit on other component that support MDLP or Hi-MD.