Honeywell 2901 User Manual page 9

ANCHORING SAFE TO A CONCRETE FLOOR
1.
Use a 1/2" Concrete Drill Bit drill a hole in the floor with a depth of 1-5/8" (Figures 1 & 2).
IMPORTANT: Hole must be 1-5/8" deep (minimum) to properly insert the Drop-in Anchor, and
no deeper than 1-3/4" to keep the anchor in position for the Hex Head Bolt (Figure 2).
2. Remove any excess dust from the hole.
3. Insert the Drop-in Anchor into the hole (slotted side down) and tap into place using a hammer
until even with the floor surface (Figure 3).
4. Secure Drop-in Anchor by inserting an anchor punch or Phillips head screwdriver into the Drop-
in Anchor and hammering to lock into place and prevent it from turning when mounting the safe (Figure 4).
5. Place the safe back into position lined up over the hole (Figure 5).
6. Insert the supplied Hex Head Bolt through the bolt-hole from the inside of the safe and into
the Drop-in Anchor (Figure 6).
7. Secure the Hex Head Bolt tightly using a socket wrench (Figure 7).
8. Replace the Mounting Hole Cap and press firmly into place (Figure 8).
Figure 1
Figure 5
ANCHORING SAFE TO A WOOD FLOOR
1. Use a 1/4" Wood Drill Bit to drill a hole in the floor with a depth of 1-1/2" (Figure 1).
2. Place the safe back into position lined up over the hole (Figure 2).
3. Insert a Wood Lag Bolt through the bolt-down hole from the inside of the safe and into the
floor hole (Figure 3).
4. Secure the Wood Lag Bolt tightly using a 9/16" socket wrench (Figure 4).
5. Replace the Mounting Hole Cap and press firmly into place.(Figure 5).
Figure 1
Figure 2
Figure 6
Figure 2 Figure 3
Figure 3
Figure 7
Figure 4
6
Figure 4
Figure 8
Figure 5