Disassembly Of Clutch Cover; Disassembly Clutch - PEUGEOT XP6 50 Manual

ASSEMBLY OF THE CLUTCH COVER
Activate the starting pedal slightly and keep it
in this position.
Remove the fixing screw from the pedal.
Loosen the pedal launcher screw and remove
the spring.
Loosen and remove the 8 fixing screws from the
cover (type CHC).
Remove the joint and the two centring bubbles
from the cover with the housing case.
IMPORTANT: Write down the position of the
starting pedal on the spindle to put it back
during the assembly (see page 25).
DISASSEMBLY OF THE CLUTCH
Loosen and remove the 4 screws (CB M5x0.80-
20), the washers and the springs from the
pressure plate.
Disassemble the upholstery discs and the plain
ones.
Take out the primary driving shaft, the ball and
the driving stick (see page 23 A B C).
Straighten the nut brake.
Immobilize the rotor clutch with tool.
Loosen and remove the nut (wrench 17) and the
nut brake.
Disassemble the rotor, grooved separator, the
plain washer (17.2x30x0.8) and the interior
cogged conical washer (write down its position
for the assembly).
Página 9 de 34