Introduction; Definition Symbols Used In This Manual - Fluke T3 Calibration Manual

Introduction

This calibration information sheet provides the following information for the T3 Tester (hereafter
referred to as "the tester"):
•
Safety information
•
Parts and service information
•
Specifications
•
Cleaning procedure
•
Required equipment
•
Performance tests
•
Calibration adjustment
•
Battery replacement procedure
•
Parts and accessories list
For operating instructions, refer to the T3 Tester Instruction Sheet.

Definition Symbols Used in this Manual

AC (alternating current)
B
DC (direct current)
F
Important information
W
On light
Earth ground
J
Conforms to CSA C22.2 No 1010-1-92 + Amendment 2 1997
N10140
Conforms to relevant Australian standards
Table 1. Symbols
Hazardous Voltage
X
Double insulated
T
Conforms to European Union
P
Directives
Beeper
R
Underwriters Laboratories
Certification
T3
1