Maintenance Instructions; Moving And Storage Instructions; Troubleshooting - Napa CARLYLE CJP400 Owner's Manual

7. MAINTENANCE INSTRUCTIONS

7.1 After use and before performing
maintenance, unplug and disconnect
the jump starter.
7.2 Use a dry cloth to wipe all battery corrosion
and other dirt or oil from the battery clips,
cords and the jump starter case.

8. MOVING AND STORAGE INSTRUCTIONS

8.1 Store inside, in a cool, dry place.
8.2 Do not store the clips on the handle,
clipped together, on or around metal, or
clipped to cables. The clips on the jump
starter are live when the switch is in the
ON position and will produce arcing or
sparking if they come in contact with each
other. To prevent accidental arcing, always
place the switch in the OFF position and
keep the clips on the storage holders when
not using it to jump start a vehicle.
8.3 If the jump starter is moved around the
shop or transported to another location,
take care to avoid/prevent damage to the
cords, clips and jump starter. Failure to
do so could result in personal injury or
property damage.
IMPORTANT: Do not use and/or store the
jump starter in or on any area or surface
where damage could occur if the internal
battery should unexpectedly leak acid.

9. TROUBLESHOOTING

Jump Starter
PROBLEM
The jump starter won't
jump start my car.
The jump starter won't
power my 12V device.
POSSIBLE CAUSE
Clips are not making a good
connection to the battery.
The jump starter battery is not
charged.
Larger engines require more
current to turn engine over, and
may require a larger jump starter.
The vehicle's battery is defective.
The 12V device is not turned on.
The jump starter's battery is not
charged.
The 12V device draws more than
15A or has a short circuit.
7.3 Ensure that all of the jump starter
components are in place and in good
working condition.
7.4 All servicing should be performed by
qualified service personnel.
8.4 IMPORTANT:
• CHARGE IMMEDIATELY AFTER
PURCHASE
• KEEP FULLY CHARGED
Charge the jump starter's internal battery
immediately after purchase, after every
use and every 30 days.
All batteries are affected by temperature.
The ideal storage temperature is at
70°F. The internal battery will gradually
self-discharge (lose power) over time,
especially in warm environments. Leaving
the battery in a discharged state may
result in permanent battery damage. To
ensure satisfactory performance and
avoid permanent damage, charge the
internal battery every month.
Check for poor connection to battery
and frame. Make sure connection
points are clean. Rock clips back and
forth for a better connection.
Check the battery charge status by
pressing the button on the front of the
jump starter. See the Digital Display
section of this manual.
Use larger jump starter.
Have the battery checked.
Turn on the 12V device.
Check the battery charge status by
pressing the button on the front of the
jump starter. See the Digital Display
section of this manual.
Disconnect the 12V device. The
internal breaker will automatically
reset after a minute or two. Try the
12V device again. If it happens again,
replace the 12V device.
• 8 •
SOLUTION