Installation and User Manual for Vice
HVQ 515 and 516 Quick-Automatic
Quick-clamping system HVQ 515 and 516 (
1. Base plate
2. Face
3. Spindle
4. Nut
5. Housing
CW
CCW
Fig. 1
1. Foreword
:
Read carefully all instructions of this User Manual, especially sections concerning work safety.
These sections are marked by a warning triangle.
2. Important notice !!
- fast feed allows free motion of the screw, which can lead to pressing of fingers between the jaws!
Be CAREFUL especially during installation
- prior to use, the vice with quick-clamping system YORK-Quick must be fixed to a workbench to
enable the gravitational component to function
- the head (7) has an opening for the capstan 25-28mm (1"-5/8")
- to ensure safe fixing of the vice, the minimum workbench thickness is 30mm (5/4")
- after unpacking, the vice must be cleaned of all preservative grease and rust on the guide rods
- prior to installation, the HVQ vice must be dismantled into two parts by removing the retaining
ring (9) and brace (8) and subsequent turning the spindle clockwise (CW) until the entire base
plate (1) slides off the guide rods (6)
- assembly is done by reverse procedure and turning the spindle counter clockwise (CCW). For
centering and inserting the spindle (3) into the nut (4), it is sometimes necessary to use an
assistance tool, for example a screwdriver
- vice installation is easier when the workbench is turned upside down
- to ensure correct vice operation it is recommended to lubricate the spindle (3) and guide rods (6)
with oil once a week
see Fig. 1
6. Guide rods
7. Head with hole for capstan 28-25mm (1,1"- 0,98")
8. Brace
9. Retaining ring
2
6
7
Page 1 (of 1)
):
3
1
5
4
8
9