Table Of Contents; Indication To The Manual; Description Of Product - Brinkmann Suction Pumps Series Operating Instructions Manual

Brinkmann-Suction Pumps Series SB20 ... SB60
Contents
1 Indication to the manual .................................... 2
2 Description of product .................................... 2-3
3 Safety instructions ............................................. 3
4 Transport and storage ....................................... 4
5 Installation and Connection ............................ 4-5
6 Start up / Shut down .......................................... 5
7 Operation ........................................................... 5
8 Servicing and Maintenance ............................... 5

1 Indication to the manual

This operating manual gives basic instructions
which are to be observed during installation, opera-
tion and maintenance of the pump. It is therefore
imperative that this manual be read by the respon-
sible personnel and operator prior to assembly and
commissioning. It is always to be kept available at
the installation site.
1.1 Identification of safety instructions in the
operating manual
Safety instructions given in this manual non-
compliance with which would affect safety are
identified by the following symbol
Safety sign according with ISO 3864 - B.3.1
or where electrical safety is involved, with:
Safety sign according with ISO 3864 - B.3.6
Where non-compliance with the safety instructions
may cause a risk to the machine and it's function
the word
ATTENTION
is inserted.

2 Description of product

2.1 General description of the pump
The suction pump operate according to the bypass
duct principle, with self-priming function following
the initial priming.
Pump and motor form a complete unit. The impeller
is fixed on the driving shaft extension. The shaft
sealing is effected with a rotary mechanical seal.
The sealing for the case is effected with a gasket
and O-ring.
The pump is to be protected against coarse parti-
cles.
The SB pumps are mounted next to or on top of the
tank. The pumps are foot mounted and must be
screwed down in order to ensure a secure stance.
BE7700
9 Trouble shooter's guide ..................................... 6
10 Spare part ......................................................... 7
11 Repair ............................................................... 8
12 Disposal ............................................................ 8
13 EC declaration of conformity ............................. 9
2.2 Intended use
The pumps SB are suitable for pumping thin-bodied
fluids within the limiting application in accordance
with table 1.
Limit of Application (Table 1)
Type
Mediums
Kinetic viscosi-
ty of the medi-
um
Temperature of
medium
Suction height
Particle-size in
the medium
min. delivery
volume
Dry running
Switching-on
frequency per
hour
Ambient tem-
perature
Set-up altitude
The pumps are to be operated within their design
limits. Applications outside of these limits are not
approved. The manufacturer is not responsible for
any damages resulting from use of the pumps in
such applications.
06/2019
Edition
SB20...SB60
Water (with anticorrosive additive),
coolants, cooling- and cutting-oils,
fuel oil
...60 mm /s
2
0 ... 80 °C
1 - 2 m without check valve
4 - 6 m with check valve
3 mm
1% of Q max.
The pumps are not suitable for dry
running.
Motors less 3 kW max. 200
40 °C
1000 m
ATTENTION
Page 2 of 9