Oki Pro8432WT User Manual page 71

Connecting Your Printer to an
Authentication Switch
1
Make sure that the printer is turned off.
2
Connect an Ethernet cable to the
network interface port.
3
Connect the Ethernet cable to the
authentication port of an authentication
switch.
4
Turn on the printer.
5 Set up the printer.
Reference
● For details on the initial setup, refer to the User's
Manual (Setup).
Changing Network Settings From the Web Page
Setting Wireless LAN (WPA/WPA2-
EAP)
Make a setting in the [IEEE802.1 X] menu
before making this setting.
Note
● IEEE802.1X functions cannot be used with wired LAN and
wireless LAN at the same time.
● To use IEEE802.1X functions with wireless LAN, make
necessary settings of IEEE802.1X and set the IEEE802.1X
menu to "Disable".
1 Open the Web page of this machine.
2
Log in as the administrator.
3 Click [Admin Setup].
4
Select [Network Menu] > [Wireless
(Infrastructure)] > [Manual Setup].
5
Select [Enable] for [Wireless
(Infrastructure)] in [Basic Settings].
6 Enter SSID name for wireless access
point you want to connect in [SSID].
7
Select [WPA/WPA2-EAP] for
[Security] in [Security Settings].
8
When all the settings in Basic Settings
and Security Settings are complete,
press [Submit] on the bottom left of
the web page to reflect the settings. It
may take approximately one minute to
establish the wireless AP connection.
If connection fails, retry the wireless
setting on the operator panel or switch
to a wired LAN on the operator panel,
and then retry the wireless setting on
the web page of the machine.
- 71 -
5