Changing The Factory Setting Of An Input Button - Sony HTD-710SF Operating Instructions Manual

Remote Operations
Button
X ws
VCR/
CD player/
DVD player/
MD deck/
Tape deck
x w;
VCR/
CD player/
DVD player/
MD deck/
Tape deck
O wj
DVD player
V/v wk
Receiver
B/b wk
Receiver
V/v/B/b wk VCR/
Satellite tuner/
DVD player
Notes
• The supplied remote can be used to control the DVD
recorder if the command modes of the DVD recorder
and remote's setting are the same. The initial setting
for the remote is "DVD 1". If you cannot control the
DVD recorder using the remote, you can change
either the factory setting of the remote (see
"Changing the factory setting of an input button" on
page 34) or the command mode of the DVD recorder
(refer to separate operating instructions supplied
with the DVD recorder).
• Some functions explained in this section may not
work depending on the model.
• The above explanation is intended to serve as an
example only. Therefore, depending on the
component the above operation may not be possible
or may operate differently than described.
• When you press input buttons (VIDEO 1, VIDEO 2
or DVD), the input mode of the TV might not switch
to the corresponding input mode that you want. In
this case, press TV/VIDEO button to switch the input
mode of the TV.
• To activate the buttons with orange printing, press
TV and the button you want simultaneously.
GB
34
Function
Pauses playback or
recording. (Also starts
recording with
components in
recording standby.)
Stops playback.
Returns to the
previous menu or
exits the menu.
Selects a menu item.
Adjusts or changes
the setting.
Selects a menu item.
.
Changing the factory
setting of an input button
If the factory settings of the input buttons do not
match your system components, you can change
them. For example, if you have a CD player and
you do not have a DVD player/DVD recorder, you
can assign the DVD button to your CD player.
1
Hold down the input button whose
input you want to change (for example,
DVD).
2
Press the corresponding button of the
component you want to assign to the
input button (for example, 5 – CD
player).
The following buttons are assigned to select
the input:
To operate
VCR (command mode VTR 3*)
VCR (command mode VTR 2*)
DVD player or
DVD recorder
(command mode DVD 1)
DVD recorder
(command mode DVD 3)
CD player
MD deck
Tape deck B
Tuner (this receiver)
DSS (Digital Satellite Receiver)
DCS (Digital CS Tuner)
BSD (Digital BS Tuner)
*Sony VCRs are operated with a VTR 2 or 3
setting. These correspond to 8 mm and VHS
respectively.
Now you can use the DVD button to control
the CD player.
To reset a button to its factory
setting
Repeat the above procedure.
To reset all the input buttons to
their factory setting
Press ?/1, TEST TONE and MASTER VOL –
at the same time.
Press
1
2
3
4
5
6
7
8
9
0/10
-/--