Amplifier Operation; Selecting The Component; Listening To Fm/Am Radio - Sony HT-DDW665 Operating Instructions Manual

Amplifier Operation

Selecting the component

1
Press input buttons to select the input.
To select the
VCR
DVD player
Built-in tuner (FM/AM) FM or AM
The selected input appears in the display.
2
Turn on the component and start
playback.
Note
If you select the VCR or DVD player, set the
TV's video input to match the component you
selected.
3
Turn MASTER VOLUME –/+ to adjust
the volume.
Note
To avoid damaging your speakers, make sure that
you turn down the volume before you turn off the
receiver.
To mute the sound
Press MUTING on the remote.
The muting function will be canceled when you
do the following.
• Press MUTING on the remote again.
• Turn the power off.
• Increase the volume.
To use the headphones
Connect the headphones to the PHONES jack.
When the headphones are connected, speaker
output is automatically canceled and "SP" does
not light up in the display.
Press
VIDEO
DVD

Listening to FM/AM radio

You can listen to FM and AM broadcasts
through the built-in tuner. Before operation,
make sure you have connected the FM and AM
antennas to the receiver (see page 7).
Tip
The tuning scale is:
FM: 100 kHz
AM: 10 kHz*
* The AM tuning scale can be changed (see page 32).
Automatic tuning
If you do not know the frequency of the station
you want, you can let the receiver scan all
available stations in your area.
1
Press FM or AM to select the FM or AM
band.
The last received station is tuned in.
2
Press TUNING + or TUNING –.
Press TUNING + to scan from low to high;
press TUNING – to scan from high to low.
The receiver stops scanning whenever a
station is received.
Tip
If "STEREO" flashes in the display and the FM stereo
reception is poor, press FM MODE to change to
monaural (MONO). You will not be able to enjoy the
stereo effect, but the sound will be less distorted. To
return to stereo mode, press FM MODE again.
continued
13 US