Alcatel 3C User Manual page 7

Your phone is a radio transmitter and receiver. It is
designed and manufactured not to exceed the emission
limits for exposure to radio-frequency (RF) energy.
These limits are part of comprehensive guidelines and
establish permitted levels of RF energy for the general
population. The guidelines are based on standards that
were developed by independent scientific organizations
through periodic and thorough evaluation of scientific
studies. These guidelines include a substantial safety
margin designed to ensure the safety of all persons,
regardless of age and health.
The exposure standard for phones employs a unit of
measurement known as the Specific Absorption Rate,
or SAR. The SAR limit set by public authorities such
as the Federal Communications Commission of the
US Government (FCC), or by Innovation, Science and
Economic Development Canada (ISEDC), is 1.6 W/kg
averaged over 1 gram of body tissue. Tests for SAR are
conducted using standard operating positions with the
phone transmitting at its highest certified power level in
all tested frequency bands.
This device is complied with SAR for general population /
uncontrolled exposure limits in ANSI/IEEE C95.1-1992
and had been tested in accordance with the measurement
methods and procedures specified in IEEE1528.
11
The FCC has granted an Equipment Authorization for
this model phone with all reported SAR levels evaluated
as in compliance with the FCC RF exposure guidelines.
SAR information on this model phone is on file with the
FCC and can be found under the Display Grant section
of www.fcc.gov/oet/ea/fccid after searching on FCC
ID:2ACCJB109
Although the SAR is determined at the highest certified
power level, the actual SAR level of the phone while
operating can be well below the maximum value. This
is because the phone is designed to operate at multiple
power levels so as to use only the power required
to reach the network. In general, the closer you are
to a wireless base station antenna, the lower the
power output of the phone. Before a phone model is
available for sale to the public, compliance with national
regulations and standards must be shown.
The highest SAR value for this model phone when tested
is 0.96 W/Kg for use at the ear and 0.91 W/Kg for use
close to the body.
While there may be differences between the SAR levels
of various phones and at various positions, they all meet
the government requirement for RF exposure.
For body-worn operation, the phone meets FCC RF
exposure guidelines provided that it is used with a non-
metallic accessory with the handset at least 15 mm
from the body. Use of other accessories may not ensure
compliance with FCC RF exposure guidelines.
12