Saving Power In Standby Mode - Sony BDV-E980W Operating Instructions Manual

Changing the preset code of
the remote (Preset mode)
1
Press HOME.
The home menu appears on the TV screen.
2
Press C/c to select
3
Press X/x to select [Remote Controller
Setting Guide], then press
4
Press X/x to select [Preset Mode], then
press
5
Press X/x to select the component type
that you want to operate with the
supplied remote, then press
6
Press X/x to select the device's
manufacturer, then press
7
Press POP UP/MENU while pressing
the operation mode button TV (for a TV)
or STB (for a cable box, digital satellite
receiver, digital video recorder, etc.).
The remote enters Preset mode. The TV or
STB operation mode button (whichever
button you pressed) starts flashing.
8
When the TV or STB operation mode
button starts flashing, enter the code
on the TV screen using the number
buttons, then press ENTER.
If you successfully set the code, the TV or
STB operation mode button will flash twice
slowly. If the setting is unsuccessful, the
TV or STB operation mode button will
flash five times quickly.
• You can quit Preset mode by pressing the TV or STB
operation mode button (whichever button is
flashing).
• If you do not operate the remote for more than 10
seconds during presetting mode, the remote exits
from presetting mode.
52
GB
[Setup].
.
Clearing the preset code from
the remote's memory
1
2
.
.
Saving Power in Standby
.
Mode
Check that the following settings are both made:
– [Control for HDMI] in [HDMI Settings] is set
to [Off] (page 63).
– [Quick Start Mode] is set to [Off] (page 64).
Press and hold AV ?/1 first, then press
2 –, then press CH –.
The BD, TV, and STB operation buttons
light up.
Release all buttons.
The BD, TV, and STB operation mode
buttons turn off and the preset code is
cleared. The remote returns to its default
settings.