Sony 4-147-229-13(1) Operating Instructions Manual page 57

2
Insert the wireless transmitter.
Rear of the unit
COMPONENT VIDEO OUT VIDEO OUT
Y
P B / C B P R / C R
HDMI OUT
LAN(100)
SPEAKER
SPEAKER
CENTER SUBWOOFER FRONT R FRONT L SUR R SUR L
Note
• Insert the wireless transmitter with the S-AIR
logo facing up.
• Insert the wireless transmitter so that the V
marks are aligned.
• Do not insert anything other than the wireless
transmitter into the EZW-T100 slot.
3
Make sure to use the same screws to
secure the wireless transmitter.
Rear of the unit
COMPONENT VIDEO OUT VIDEO OUT
Y P / C P / C
B B R R
HDMI OUT
LAN(100)
SPEAKER
SPEAKER
CENTER SUBWOOFER FRONT R FRONT L SUR R SUR L
Note
• Do not use other screws to fasten the wireless
transmitter.
To insert the wireless
transceiver into the S-AIR sub
unit
For details on installing the wireless transceiver
into the S-AIR sub unit, such as a surround
amplifier or S-AIR receiver, see the operating
instructions of the S-AIR sub unit.
ANTENNA
EZW-T100 COAXIAL 75
FM
AM
SAT/CABLE TV EXT TV AUDIO
DIGITAL IN DIGITAL IN DC5V 500mA MAX
L L
DMPORT
A. CAL MIC
DC5V ECM-AC2
700mA MAX
R R
COAXIAL OPTICAL AUDIO IN AUDIO IN
ANTENNA
EZW-T100 COAXIAL 75
FM
TV AUDIO AM
SAT/CABLE TV EXT
DIGITAL IN DIGITAL IN DC5V 500mA MAX
L L
DMPORT A. CAL MIC
DC5V ECM-AC2
700mA MAX
R R
AUDIO IN AUDIO IN
COAXIAL OPTICAL
Tip
• When you change the S-AIR configuration, Sony
recommends that you perform [Auto Calibration].
For details, see "Calibrating the Appropriate Settings
Automatically" (page 66).
Establishing sound
transmission between the unit
and S-AIR sub unit
(ID setting)
For the surround amplifier
For the S-AIR receiver
Simply by matching the ID of the unit and the
S-AIR sub unit, you can establish sound
transmission.
To set the ID of the unit
1
Press "/1 on the unit.
The system turns on.
2
Press SYSTEM MENU.
3
Press X/x repeatedly until "S-AIR
MENU" appears in the front panel
display, then press
4
Press X/x repeatedly until "S-AIR ID"
appears in the front panel display, then
press or c.
Note
• When the wireless transmitter is not inserted in
the unit, "S-AIR ID" cannot be selected.
5
Press X/x to select the desired ID.
You can select any ID (A, B, or C).
6
Press .
The setting is made.
7
Press SYSTEM MENU.
The system menu turns off.
8
Set the S-AIR sub unit to the same ID.
Sound transmission is established as
follows (example):
or c.
57
US