Sony 3-295-946-12(1) Operating Instructions Manual page 26

2
Press V/v repeatedly to select
the item. Then, press
Item
RETRY
SAVE
WARN CHK
PHASE
DISTANCE
LEVEL
EXIT
3
Save the measurement result.
Select "SAVE" in step 2.
The measurement results are saved.
26 GB
.
Explanation
Performs the Auto
Calibration again.
Saves the measurement
results and exits the setting
process.
Displays warning
concerning the
measurement results. See
"When you select "WARN
CHK"" (page 27).
Displays the phase of each
speaker (in phase/out of
phase). See "When you
select "PHASE"" (page 27).
Displays the measurement
result for speaker distance.
Displays the measurement
result for speaker level.
Exits the setting process
without saving the
measurement results.
When error codes appear
Try the remedies and perform the Auto
Calibration again.
Error code Cause and remedies
ERROR 32 None of the speakers were
detected. Make sure that the
optimizer microphone is
connected properly and perform
the Auto Calibration again.
If the optimizer microphone is
connected properly but the error
code appears, the optimizer
microphone cable may be
damaged or improperly connected.
ERROR F 33 • None of the front speakers are
connected or only one front
speaker is connected.
• The optimizer microphone is not
connected.
ERROR SR 33 Either the left or right surround
speakers is not connected.
ERROR SW 33 Subwoofer is not connected.
Connect the subwoofer to the
SUBWOOFER terminal.
ERROR 33 Wrong speaker detection due to
noise. Make sure the environment
is quiet during Auto Calibration.
ERROR 35 A sound similar to the beep sound
from the speakers while
performing Auto Calibration is
detected. Perform the Auto
Calibration again.
To rectify the error
1
Record down the error code.
2
Press , "RETRY Y" appears on the
display.
3
Rectify the error.
For details, see "When error codes appear"
above.
4
Press to perform Auto Calibration again.