Philips 32HF7445/93 Service Manual page 16

EN 16 5. TPT1.1HA LA
Figure 5-2 Factory menu [1/3]
Figure 5-3 Factory menu [2/3]
Figure 5-4 Factory menu [3/3]
How to Navigate
When you press the up/down cursor keys you can move
around the items, with the Right cursor you can select an item
and enter it. With the jaMENU button on the remote control, the
set will switch on the normal user menu in the Factory mode.
How to Exit
Switch the set to STANDBY by pressing the POWER button on
the remote control transmitter.
If you turn the television set off by removing the AC Power (i.e.,
unplugging the television) or by using the POWER button on
the TV set, the television set will remain in SDM when AC
Power is re-applied, and the error buffer is not cleared.
江南家电维修论坛会员专用！
http://bbs.520101.com
Service Modes, Error Codes, and Fault Finding
H_17010_017.eps
180907
H_17010_019.eps
180907
H_17010_018.eps
180907
5.1.4 Hotel Mode
Before the hotel mode can be activated, the set needs to be
switched into normal consumer mode first. Use an ITV setup
remote control (type: RC2573/01, 12NC: 3139 228 88782) and
key in the code "024995" directly followed by the "M" (Menu)
key. The test messages "TV is Now In MTV Mode" and "Please
Do A Cold Start!" appear on the screen.
Disconnect the set for a few seconds from the mains supply,
and reconnect the set to again. After switching the set "on", the
set is in normal consumer mode (MTV-Mode).
After repair, put the set into hotel mode (iTV-Mode) again.
Enter the same code on the remote control as described
above. The text messages "TV Is Now In ITV Mode" and
"Please Do A Cold Start!" appears. Disconnect the set for a few
seconds from the mains supply, and reconnect it to the mains
supply again. After switching "on", the set is in normal
consumer mode (MTV-Mode).