Troubleshooting - Sony MDR DS6000 Operating Instructions Manual

1 Additional Information

Troubleshooting

If you run into any problems using this headphone system, use the following
checklist. Should any problem persist, consult your nearest Sony dealer.
Symptom Cause and remedy
No sound
, Check the connection between the processor and the AV component.
, Check that the signal is not being input to the digital out jack by mistake when
, Check that the connected AV component's optical digital output is set to "ON"
, Turn on the AV component connected to the processor, and start the playback.
, Check that the INPUT SELECT switch on the processor is set to the
, If you connect the processor to an AV component using the headphone jack,
, Make sure you are wearing the headphones correctly.
, Raise the headphone volume.
, The headphones' POWER indicator goes off.
, You are trying to play a DTS audio track on a DVD device that does not
, You are playing back a DVD disc recorded in DTS when DTS digital output
, You are playing back a DVD disc recorded in DTS when the DVD device
, The processor's ID is not set for the additional headphones.
, Additional headphones are being charged.
digital input is selected.
when selecting digital input.
component you want to listen to.
raise the volume level on the connected AV component.
• Charge the rechargeable battery if it is weak, or replace alkaline batteries
with new ones. If the POWER indicator is still off after charging the battery,
take the headphones to a Sony dealer.
support DTS.
• Either use a DVD device that supports DTS, or select a Dolby Digital or
PCM audio track.
setting for the DVD device (including game machines) is "OFF."
• See the instruction manual of your DVD device, and change the DTS digital
output setting to "ON."
(including game machines) and the processor are analog-connected.
• Use the digital connection. (Analog sound may not be output from the DVD
device.)
• Remove additional headphones from the processor.
Additional Information
(Continued)
US
25