Connecting And Setting The Tv; Basic Connections (Connecting Cable Or An Antenna); Connector Types; Connecting Directly To Cable Or An Antenna - Sony WEGA KLV 23M1 Operating Instructions Manual

Connecting and
Setting the TV
Basic Connections
(Connecting Cable or an
Antenna)

Connector types

You may find it necessary to use some of the
following connector types during set up.
Supplied 75-ohm coaxial cable
Screw-on type
S VIDEO cable
High quality video cable for enhanced picture quality
AUDIO/VIDEO cable
VIDEO - Yellow
AUDIO (Left) - White
AUDIO (Right) - Red
Some DVD players are equipped with the following
three video connectors:
Y - Green
P (C , C or B-Y) - Blue
B B b
P (C , C or R-Y) - Red
R R r
HDMI cable
High definition multimedia interface cable
24
Screw into connector
Align guides and push into
connector
Push into connector
Push into connector
Align guides and push into
connector
Connecting directly to cable or an
antenna
VHF only or VHF/UHF or cable
75-ohm coaxial
cable (supplied)
Also, set "Cable" to "Off" in the
menu (see page 37).
Notes
• It is strongly recommended to connect the antenna using a 75-
ohm coaxial cable to get optimum picture quality. A 300-ohm
twin lead cable can be easily affected by radio noise and the
like, resulting in signal deterioration. If you use a 300-ohm
twin lead cable, keep it away as far as possible from the TV.
• Do not detach the ferrite core from the supplied 75-ohm
coaxial cable.
• The ferrite core is attached to one end of (not the center of) the
supplied 75-ohm coaxial cable. When connecting the cable to
the TV, insert the end with the ferrite core into the VHF/UHF
jack.

Cable box connections

Use this hookup if:
• You subscribe to a cable TV system that uses
scrambled or encoded signals requiring a cable
box to view all channels, and
• You do not intend to hook up any other audio or
video equipment to your TV.
1
Connect the coaxial connector from your cable
service to the cable box's IN jack.
2
Using the supplied 75-ohm coaxial cable,
connect the cable box's OUT jack to the TV's
VHF/UHF jack.
Cable
75-ohm coaxial
cable (supplied)
IN
OUT
jack
jack
Cable box
Tips
• The supplied remote control can be programmed to operate
your cable box (see "Programming the Remote Control" on
page 16).
• To change channels using the cable box, set your TV to
channel 3 or 4 depending on the cable box channel output.
• If you will be controlling all channel selection through your
cable box, consider using the Channel Fix feature to set your
TV to channel 3 or 4 (see page 38).
Rear of TV
VHF/UHF jack
(Channel)
Rear of TV
VHF/UHF jack